Oil Level Sensor for BMW X5 E53 3.0i X3 E83 530i 525i Z4 E85 M54 12617508003 Oil Level Sensor for BMW X5 E53 3.0i X3 E83 530i 525i Z4 E85 M54 12617508003 Oil Level Sensor for BMW X5 E53 3.0i X3 E83 530i 525i Z4 E85 M54 12617508003 Oil Level Sensor for BMW X5 E53 3.0i X3 E83 530i 525i Z4 E85 M54 12617508003

Oil Level Sensor for BMW X5 E53 3.0i X3 E83 530i 525i Z4 E85 M54 12617508003

Part #: SCPS180 Replaces OEM: 12617508003

OEM Spec Fit Replaces 12617508003

$149.95
RRP $179.97
SAVE $30.02 (17%)
In Stock

BRAND NEW *OEM Quality* oil level sensor to suit BMW X5 E53, X3 E83 and 5 Series with the M54 six-cylinder petrol engine.

A false check-oil-level warning on a big six-cylinder BMW is usually the sump sensor, not the oil. Swap it out in under an hour - dispatched same day from Melbourne.

TO SUIT

Made for the BMW X5 E53 3.0i (M54B30, 2000-2006) and X3 E83 2.5i and 3.0i (M54, 2004-2006), plus the later X3 2.5si and xDrive25i with the N52. It also suits the E39 530i, E60 525i and 530i, Z4 E85 2.5i and 3.0i, and Z3 2.0i and 2.8i (M52). Owners of an E46 3 Series or an M62 V8 should see our model-specific listings.

FITMENT CHECK

Match the number on your old sensor to 12617508003 or one of the OEM numbers below. The sensor bolts into the bottom of the sump with three bolts, so drain the oil first.

OEM PART NUMBERS

  • 12617508003
  • 12611433596
  • 12611439810
  • 12617832375
  • 13617832205
  • 7508003
  • 1439810
  • 7832205
  • 7832375

OTHER PART NUMBERS

  • V20-72-0462
  • 6PR 007 868-031
  • EPO-BM-000
  • 20 92 3907
  • 23907
  • 501 522
  • 314 800 0051
  • LS119
  • OLS1000
  • OPS180

PACKAGE INCLUDES

1 x oil level sensor with seal ring, 3-pin D-shaped connector, 3 mounting bolt holes.

ABOUT THIS SENSOR

The oil level sensor sits in the sump and reports oil level and temperature to the instrument cluster. On the X5 and X3 the cluster uses it for the oil level check shown at start-up.

When the sensor fails the warning either stays on with a full sump or never comes on at all, so a real low-oil condition can go unnoticed on a high-kilometre M54.

COMMON SYMPTOMS OF FAILURE

  • Check Control message asking you to check the engine oil level when the level is correct
  • Low oil level warning that comes and goes after the engine warms up
  • No oil level reading in the instrument cluster or on-board computer
  • Oil level warning stays on after an oil change or top-up
  • Oil weeping from the sensor seal on the bottom of the sump
  • [04/00 - 10/06] BMW X5 E53 3.0i (3.0L 6CYL M54B30 170kW)
  • [06/00 - 12/06] BMW X5 E53 3.0i (3.0L 6CYL M54B30 168kW)
  • [06/04 - 07/06] BMW X3 E83 2.5i (2.5L 6CYL M54B25 141kW)
  • [06/04 - 07/06] BMW X3 E83 3.0i (3.0L 6CYL M54B30 170kW)
  • [08/06 - 08/08] BMW X3 E83 2.5si (2.5L 6CYL N52B25 160kW)
  • [09/08 - 08/10] BMW X3 E83 xDrive25i (2.5L 6CYL N52B25 160kW)
  • [09/00 - 12/03] BMW 5 SERIES E39 530i WAGON (3.0L 6CYL M54B30 170kW)
  • [03/01 - 06/03] BMW 5 SERIES E39 530i SEDAN (3.0L 6CYL M54B30 170kW)
  • [09/03 - 02/05] BMW 5 SERIES E60 525i SEDAN (2.5L 6CYL M54B25 141kW)
  • [09/03 - 02/05] BMW 5 SERIES E60 530i SEDAN (3.0L 6CYL M54B30 170kW)
  • [07/03 - 12/06] BMW Z4 E85 2.5i ROADSTER (2.5L 6CYL M54B25 141kW)
  • [07/03 - 12/05] BMW Z4 E85 3.0i ROADSTER (3.0L 6CYL M54B30 170kW)
  • [11/96 - 05/00] BMW Z3 E36 2.8i ROADSTER (2.8L 6CYL M52B28 142kW)
  • [06/99 - 10/00] BMW Z3 E36 2.0i ROADSTER (2.0L 6CYL M52B20 110kW)
  • [01/99 - 08/00] BMW 3 SERIES E36 316i COMPACT (1.9L 4CYL M43B19 77kW)
What does an oil level sensor do?

The oil level sensor monitors the volume of engine oil in the sump and alerts the driver when the level drops below a safe threshold. It provides an early warning before oil level drops low enough to affect oil pressure and cause engine damage. Unlike the oil pressure sensor which monitors operating pressure while the engine is running, the oil level sensor typically reads level when the engine is off or at idle and the oil has settled in the sump.

What are the symptoms of a failing oil level sensor?

Common symptoms include an oil level warning light on the dashboard despite the dipstick confirming correct oil level, no warning light appearing even when oil is actually low, and intermittent warnings that appear when the engine is cold and disappear once the engine warms up. A Check Engine light with oil level circuit fault codes may also be present. Always verify actual oil level with the dipstick before assuming the sensor has failed.

How does the oil level sensor work?

Most modern oil level sensors use a thermistor-based measurement system. A heating element warms the sensor tip and the rate at which heat dissipates indicates whether the tip is submerged in oil or exposed to air - oil conducts heat away faster than air. Some older vehicles use a float-based sensor similar to a fuel level sender. The ECU interprets the sensor signal and triggers the warning light when oil level is below the minimum mark.

Can I ignore an oil level warning if my dipstick shows the oil is correct?

A single occurrence of an oil level warning with a correct dipstick reading suggests a faulty sensor. However do not ignore repeated warnings - recheck the dipstick carefully, ensuring the vehicle is on level ground and the engine has been off for at least five minutes to allow oil to drain back into the sump. If the dipstick consistently shows correct level and the warning persists, replace the sensor. If the dipstick shows low oil, top up immediately.

Is the oil level sensor the same as the oil pressure sensor?

No - they are two completely different sensors monitoring different things. The oil level sensor measures the volume of oil in the sump and is a maintenance warning device. The oil pressure sensor measures the pressure of oil circulating through the engine and is a real-time engine protection device. A low oil level will eventually cause low oil pressure, but the level sensor provides an earlier warning. Most vehicles have both sensors fitted separately.

Does replacing the oil level sensor require draining the engine oil?

On most vehicles yes - the oil level sensor is mounted in the oil sump below the oil level, so the engine oil must be drained before the sensor can be removed without spillage. Use this as an opportunity to perform an oil and filter change at the same time, as draining the oil is the main labour component of a service. Refill with the correct grade and quantity of oil specified for your engine after fitting the new sensor.

Identification
BrandAftermarket OEM Replacement
Part Numbers
Part NumberSCPS180
Reference OEM Number12617508003
Other OEM Numbers12617508003, 12611433596, 12611439810, 12617832375, 13617832205
Related Part NumbersLS119, OLS1000, CPS180, EPO-BM-000, OPS180
Interchange Part NumbersV20-72-0462, 6PR007868031, EPO-BM-000, 20923907, 23907, 501522
Product Specifics
Product TypeSENSOR
Sensor TypeOil Level Sensor
Number of pins3-Pin
Connector ShapeD-shaped
Fitting Depth90 mm
Housing ColourBlack
Housing TypeAluminium Housing
Number of mounting bores3
Compatible MakesBMW
Fitment TypeDirect Replacement
Other Details
NoteAlways verify fitment using your vehicle's OEM part number.

Be The First To Review This Product!

Help other SENSORGAL LTD. users shop smarter by writing reviews for products you have purchased.

Write a product review

More From This Category