Oil Level Sensor for BMW 1 Series E87 E82 E88 116i 118i 120i N45 N46 12617501786 Oil Level Sensor for BMW 1 Series E87 E82 E88 116i 118i 120i N45 N46 12617501786 Oil Level Sensor for BMW 1 Series E87 E82 E88 116i 118i 120i N45 N46 12617501786 Oil Level Sensor for BMW 1 Series E87 E82 E88 116i 118i 120i N45 N46 12617501786

Oil Level Sensor for BMW 1 Series E87 E82 E88 116i 118i 120i N45 N46 12617501786

Part #: SCPS169 Replaces OEM: 12617501786

OEM Spec Fit Replaces 12617501786

$97.99
RRP $169.00
SAVE $71.01 (42%)
In Stock

BRAND NEW *OEM Quality* oil level sensor to suit the BMW 1 Series petrol with the N45, N46 or N43 engine.

If your 1 Series keeps asking you to check the oil after a top-up, the sump sensor is the usual cause. Packed and shipped same day from Cranbourne VIC.

TO SUIT

Built for the BMW E87 1 Series hatch 116i (N45B16), 118i and 120i (N46B20 and N43B20), 2004-2011. It also suits the E82 120i coupe and E88 120i convertible to 2013. The 1 Series diesels use a different sensor.

OEM PART NUMBERS

  • 12617501786
  • 7501786

OTHER PART NUMBERS

  • V20-72-0468
  • 6PR 008 324-101
  • 7.13500.01.0
  • EPO-BM-001
  • 20 92 6154
  • 26154
  • 501 521
  • 314 899 0028
  • LS121
  • OLS1012
  • OPS169

PACKAGE INCLUDES

1 x oil level sensor with seal ring, 3-pin D-shaped connector, 3 mounting bolt holes.

ABOUT THIS SENSOR

On the 1 Series the sensor sits in the bottom of the sump and feeds the oil level check the cluster runs at start-up and on the Check Control screen.

When it fails you lose the oil level reading or get a constant warning, which on a high-kilometre N46 can hide real oil consumption.

COMMON SYMPTOMS OF FAILURE

  • Check Control message asking you to check the engine oil level when the level is correct
  • Low oil level warning that comes and goes after the engine warms up
  • No oil level reading in the instrument cluster or on-board computer
  • Oil level warning stays on after an oil change or top-up
  • Oil weeping from the sensor seal on the bottom of the sump
  • [06/04 - 06/11] BMW 1 SERIES E87 116i HATCH (1.6L 4CYL N45B16 85kW)
  • [07/04 - 02/07] BMW 1 SERIES E87 118i HATCH (2.0L 4CYL N46B20 95kW)
  • [10/06 - 06/11] BMW 1 SERIES E87 118i HATCH (2.0L 4CYL N46B20 100kW)
  • [06/04 - 02/07] BMW 1 SERIES E87 120i HATCH (2.0L 4CYL N46B20 110kW)
  • [03/07 - 06/11] BMW 1 SERIES E87 120i HATCH (2.0L 4CYL 115kW)
  • [03/07 - 06/11] BMW 1 SERIES E87 120i HATCH (2.0L 4CYL N43B20 125kW)
  • [09/09 - 10/13] BMW 1 SERIES E82 120i COUPE (2.0L 4CYL N46B20 115kW)
  • [03/08 - 12/13] BMW 1 SERIES E88 120i CONVERTIBLE (2.0L 4CYL N46B20 115kW)
  • [03/08 - 12/13] BMW 1 SERIES E88 120i CONVERTIBLE (2.0L 4CYL N43B20 120kW)
What does an oil level sensor do?

The oil level sensor monitors the volume of engine oil in the sump and alerts the driver when the level drops below a safe threshold. It provides an early warning before oil level drops low enough to affect oil pressure and cause engine damage. Unlike the oil pressure sensor which monitors operating pressure while the engine is running, the oil level sensor typically reads level when the engine is off or at idle and the oil has settled in the sump.

What are the symptoms of a failing oil level sensor?

Common symptoms include an oil level warning light on the dashboard despite the dipstick confirming correct oil level, no warning light appearing even when oil is actually low, and intermittent warnings that appear when the engine is cold and disappear once the engine warms up. A Check Engine light with oil level circuit fault codes may also be present. Always verify actual oil level with the dipstick before assuming the sensor has failed.

How does the oil level sensor work?

Most modern oil level sensors use a thermistor-based measurement system. A heating element warms the sensor tip and the rate at which heat dissipates indicates whether the tip is submerged in oil or exposed to air - oil conducts heat away faster than air. Some older vehicles use a float-based sensor similar to a fuel level sender. The ECU interprets the sensor signal and triggers the warning light when oil level is below the minimum mark.

Can I ignore an oil level warning if my dipstick shows the oil is correct?

A single occurrence of an oil level warning with a correct dipstick reading suggests a faulty sensor. However do not ignore repeated warnings - recheck the dipstick carefully, ensuring the vehicle is on level ground and the engine has been off for at least five minutes to allow oil to drain back into the sump. If the dipstick consistently shows correct level and the warning persists, replace the sensor. If the dipstick shows low oil, top up immediately.

Is the oil level sensor the same as the oil pressure sensor?

No - they are two completely different sensors monitoring different things. The oil level sensor measures the volume of oil in the sump and is a maintenance warning device. The oil pressure sensor measures the pressure of oil circulating through the engine and is a real-time engine protection device. A low oil level will eventually cause low oil pressure, but the level sensor provides an earlier warning. Most vehicles have both sensors fitted separately.

Does replacing the oil level sensor require draining the engine oil?

On most vehicles yes - the oil level sensor is mounted in the oil sump below the oil level, so the engine oil must be drained before the sensor can be removed without spillage. Use this as an opportunity to perform an oil and filter change at the same time, as draining the oil is the main labour component of a service. Refill with the correct grade and quantity of oil specified for your engine after fitting the new sensor.

Identification
BrandAftermarket OEM Replacement
Part Numbers
Part NumberSCPS169
Reference OEM Number12617501786
Other OEM Numbers12617501786, 7501786
Related Part NumbersCPS169, LS121, 6PR008324-101, EPO-BM-001, OLS1012, OPS169
Interchange Part NumbersV20-72-0468, 6PR008324-101, 7.13500.01.0, EPO-BM-001, 20926154
Product Specifics
Product TypeSENSOR
Sensor TypeOil Level Sensor
Number of pins3-Pin
Connector ShapeD-shaped
Fitting Depth82 mm
Number of mounting bores3
Compatible MakesBMW
Fitment TypeDirect Replacement
Other Details
NoteAlways verify fitment using your vehicle's OEM part number.

Be The First To Review This Product!

Help other SENSORGAL LTD. users shop smarter by writing reviews for products you have purchased.

Write a product review

More From This Category