Camshaft Crankshaft & Coolant Sensor Kit for Holden V6 3800 Ecotec 10456161

BRAND NEW *OEM Quality* 3-piece engine sensor kit to suit Holden Commodore, Calais, Statesman, Caprice and Monaro V2 3.8L V6.

Hot-start refusal, stalling without warning, and poor fuel economy on a 3.8L V6 usually trace back to the same three sensors. Replacing them together restores the ECU's timing and temperature reference in one job, packed and shipped from Cranbourne VIC.

TO SUIT

This kit suits the Holden Commodore VR VS VT VU VX VY, Calais VR to VY, Statesman and Caprice VR VS WH WK, Monaro V2, Crewman and One Tonner VY, from 1993 to 2004. It also covers the HSV Grange WH, XU6 VT and VX, HDT Commodore VT and the Toyota Lexcen VR and VS.

FITMENT CHECK

This kit covers VR onwards only. The coolant temperature sensor does not fit the earlier VN, VG, VP or VQ cars, so those platforms are not included even though the cam and crank sensors suit them. Buy those two separately if you have a pre-VR car.

OEM PART NUMBERS

• Crankshaft sensor: 10456161 / 12567649 / 24506905
• Camshaft sensor: 10456148 / 8-10456-148-0 / 8104561480
• Coolant sensor: 12146312 / 15326386 / 25036979 / 25037082

OTHER PART NUMBERS

• BOSCH: F005X03175
• VEMO: V51-72-0196
• VEMO: V51-72-0184
• VEMO: V40-72-0330-1
• ACDelco: 213-151
• WALKER PRODUCTS: 211-1012
• NTK-AU: EC0054

PACKAGE INCLUDES

1 x Crankshaft Position Sensor - 4-pin oval connector. 1 x Camshaft Position Sensor - 3-pin oval connector. 1 x Engine Coolant Temperature Sensor - 2-pin oval connector.

ABOUT THIS KIT

The crank and cam sensors tell the ECU where the engine is in its cycle so it can time spark and injection. The coolant sensor tells it how warm the engine is so it can set fuel enrichment and run the thermo fan. All three sit in the same heat, and on a car past 200000km they tend to drift together.

Replacing one and leaving the others is why these faults often come back a few months later. Doing all three at once costs less than the three sensors bought separately and only takes the engine bay apart once.

COMMON SYMPTOMS OF FAILURE

• Engine cranks but will not start once hot
• Stalling without warning at idle or low speed
• Check engine light with DTC P0335 P0336 P0340 P0341 P0117 or P0118
• Temperature gauge reading erratically or thermo fan not cutting in
• Rough idle misfires or hesitation under load
• Poor fuel economy and hard cold starting