Fuel Temperature Sensor for Porsche Cayenne (92A) MACAN (95B) Panamera (970) Fuel Temperature Sensor for Porsche Cayenne (92A) MACAN (95B) Panamera (970) Fuel Temperature Sensor for Porsche Cayenne (92A) MACAN (95B) Panamera (970) Fuel Temperature Sensor for Porsche Cayenne (92A) MACAN (95B) Panamera (970)

Fuel Temperature Sensor for Porsche Cayenne (92A) MACAN (95B) Panamera (970)

Part #: SCTS2048-Porsche Replaces OEM: 95560622100

OEM Spec Fit Replaces 95560622100

$127.97
RRP $237.97
SAVE $110.00 (46%)
In Stock

BRAND NEW *OEM Quality* fuel temperature sensor for Porsche Cayenne Macan Panamera diesel models.

A failing fuel temperature sensor sends inaccurate readings to the ECU, causing rough running, poor fuel economy or a Check Engine light. This direct-fit replacement is dispatched same-day from Cranbourne VIC.

TO SUIT

Suits the Porsche Cayenne 92A, Macan 95B and Panamera 970 3.0 V6 and 4.2 V8 diesel models. This is a different physical sensor to our Audi/VW/Skoda fuel temperature sensor listing (OEM 059919523A) - this Porsche-specific part uses OEM number 95560622100 or 958919523, so check your original part number before ordering.

FITMENT CHECK

Confirm your original sensor's OEM number matches 95560622100 or 958919523 before ordering. Some Cayenne, Macan and Panamera diesel variants use a different sensor fitted at the cylinder head or paired with an injector pump, which this part does not suit.

OEM PART NUMBERS

  • 95560622100
  • 958919523

PACKAGE INCLUDES

1 x Fuel Temperature Sensor.

ABOUT THIS SENSOR

The fuel temperature sensor is an NTC sensor that measures fuel temperature and reports it to the ECU, which uses the reading to fine-tune injection timing and fuel quantity on Porsche's V6 and V8 diesel engines.

A failing sensor commonly triggers fault code P0182 or P0183, along with reduced power, black exhaust smoke or a rough idle.

COMMON SYMPTOMS OF FAILURE

  • Check Engine light with fault code P0182 or P0183
  • Rough idle or hesitation under load
  • Reduced fuel economy
  • Black or excessive exhaust smoke
  • Engine enters limp/failsafe mode
  • Difficulty starting in cold weather
How do I test a coolant temperature sensor?

The most common test is to measure the sensor resistance with a multimeter at a known coolant temperature and compare against the manufacturer resistance curve. A cold engine (20 degrees C) typically reads 2,000 to 3,000 ohms and drops to around 200 to 300 ohms at operating temperature (90 degrees C). An OBD2 scanner showing a fixed temperature reading that does not change as the engine warms up is also a strong indicator of sensor failure.

Can a faulty coolant temperature sensor cause my engine to overheat?

Indirectly yes. If the sensor reports a lower temperature than actual, the ECU may not activate the cooling fan at the correct time, allowing the engine to overheat. It can also suppress the dashboard warning light, meaning you may not be alerted until the engine is already at a dangerously high temperature. Replace a suspected faulty sensor promptly.

Do I need to drain the coolant to replace the sensor?

Not always - many coolant temperature sensors can be replaced quickly with minimal coolant loss if you work fast and have a replacement ready to thread in immediately. However on some vehicles the sensor location requires partial coolant drainage. Check the sensor position on your specific engine before starting. Always use fresh coolant when topping up after replacement.

What are the symptoms of a faulty coolant temperature sensor?

Symptoms include poor fuel economy, black smoke, engine overheating warning, incorrect temperature gauge reading, hard starting when cold, and rough idle. Fault codes P0115 to P0119 are commonly associated with coolant temperature sensor faults.

Is it safe to drive with a bad coolant temperature sensor?

A faulty coolant temperature sensor can cause the ECU to run rich fuel mixtures and prevent the cooling fan from operating correctly, risking engine overheating. Replace it promptly - it is a low-cost part that can prevent expensive engine damage.

How do I know if my coolant temperature sensor or my thermostat is faulty?

A faulty thermostat typically causes the engine to overheat or never reach operating temperature. A faulty coolant temp sensor causes incorrect gauge readings and running issues but the coolant itself may be at the correct temperature. An OBD2 scanner showing live coolant temp data helps distinguish between the two.

Are there two coolant temperature sensors on my vehicle?

Many vehicles have two sensors - one for the ECU (engine management) and one for the dashboard temperature gauge. They look similar but are not interchangeable. Check your vehicle's service manual or contact us with your vehicle details to confirm which sensor you need.

Identification
BrandAftermarket OEM Replacement
Part Numbers
Part NumberSCTS2048-Porsche
Reference OEM Number95560622100
Other OEM Numbers95560622100, 958919523
Related Part NumbersCTS2048
Product Specifics
Product TypeSENSOR
Sensor TypeFUEL TEMPERATURE SENSOR
Compatible MakesPorsche
Fitment TypeDirect Replacement
Other Details
NoteAlways verify fitment using your vehicle's OEM part number.
Unit Of Measureea

Be The First To Review This Product!

Help other SENSORGAL LTD. users shop smarter by writing reviews for products you have purchased.

Write a product review

More From This Category