Fuel and Coolant Temperature Sensor for Toyota Ford Isuzu Holden Fuel and Coolant Temperature Sensor for Toyota Ford Isuzu Holden Fuel and Coolant Temperature Sensor for Toyota Ford Isuzu Holden Fuel and Coolant Temperature Sensor for Toyota Ford Isuzu Holden

Fuel and Coolant Temperature Sensor for Toyota Ford Isuzu Holden

Part #: FTS105 OEM #: 89454-60010 SKU: 8945460010

Workshop Grade Replaces 89454-60010

$74.97
RRP $110.97
SAVE $36.00 (32%)
In Stock

BRAND NEW *OEM Quality* fuel and coolant temperature sensor cross-referenced across Toyota, Ford, Isuzu, Holden, Opel and Suzuki.

This sensor is used as a fuel temperature sensor on some models and a coolant temperature sensor on others, depending on where the manufacturer fitted it. Same-day dispatch before 12pm from Cranbourne VIC.

TO SUIT

  • Toyota Coaster Bus 4.2L, 1993 to 2003
  • Toyota HiAce and HiAce/Commuter, 2.5L to 3.0L Diesel, 2004 onward
  • Toyota Hilux KUN16 and KUN26, 3.0L Turbo Diesel, 2005 to 2015
  • Toyota LandCruiser HDJ100 and LandCruiser 200 Series VDJ200, 4.2L to 4.5L Diesel, 1998 onward
  • Toyota LandCruiser Prado KZJ90 KZJ95 KZJ120 KDJ120 KDJ125 KDJ150 KDJ155, 3.0L Diesel, 1995 onward
  • Toyota RAV4 ALA49, 2.2L Diesel, 2012 onward
  • Ford Transit VM, 2.2L to 2.4L Diesel, 2006 to 2014
  • Isuzu D-MAX, Isuzu MU-X, Holden Colorado and Holden Rodeo - see our dedicated Isuzu D-MAX listing for full model and year coverage
  • Also cross-referenced to Opel and Suzuki OEM part numbers, see Other Part Numbers below

FITMENT CHECK

This is the oval 2-pin connector variant. Compare the connector shape on your original sensor before ordering, as some vehicles listed above use a different housing.

OEM PART NUMBERS

  • 89454-20010
  • 89454-60010
  • 89454-60020
  • 98023581
  • 97216283
  • 8-98023-581-0
  • 1441571
  • 6C1Q-9F95-1AA
  • 62 38 154
  • 62 35 749
  • 15280-78E10
  • 15280-78E10-000

OTHER PART NUMBERS

  • V32-72-0024
  • 6PT 013 113-141

PACKAGE INCLUDES

1 x Fuel/Coolant Temperature Sensor, 2-pin oval connector, direct plug-in fitment.

ABOUT THIS SENSOR

Fuel and coolant temperature sensors report fluid temperature to the ECU, which uses this data to fine-tune injection timing, fuelling and ignition timing depending on where the sensor is fitted.

This sensor design is shared across several manufacturers who source the same base part under their own OEM part numbers, so a single physical sensor covers a wide cross-reference range.

COMMON SYMPTOMS OF FAILURE

  • Check Engine Light with a temperature sensor fault code
  • Rough or unstable idle
  • Poor fuel economy
  • Inaccurate or erratic temperature gauge
  • Reduced power or ECU limp-home mode
  • Hard starting when cold
  • [01/93 - 10/03] TOYOTA COASTER BUS 4.2L 4cyl HZB50
  •  
  • [06/04 - on] TOYOTA HIACE VAN 2.5L 4cyl D-4D (KDH200 KDH20_ KDH21_ KDH22_)
  • [05/10 - on] TOYOTA HIACE VAN 3.0L 4cyl D (KDH201 KDH221)
  • [08/04 - on] TOYOTA HIACE/COMMUTER BUS 3.0L 4cyl D (KDH203_ KDH221 KDH223)
  • [05/10 - on] TOYOTA HIACE/COMMUTER BUS 3.0L 4cyl D (KDH223)
  •  
  • [08/06 - 05/15] TOYOTA HILUX PICKUP 3.0L 4cyl D (KUN16)
  • [03/05 - 05/15] TOYOTA HILUX PICKUP 3.0L 4cyl D-4D 4WD (KUN26)
  • [08/05 - 09/15] TOYOTA HILUX PICKUP 3.0L 4cyl D-4D 4WD (KUN26)
  •  
  • [01/98 - 08/07] TOYOTA LANDCRUISER 4.2L 6cyl TD (HDJ100_ HDJ100)
  • [09/07 - on] TOYOTA LANDCRUISER 4.5L 8cyl D-4D (VDJ200)
  •  
  • [04/95 - 07/00] TOYOTA LANDCRUISER PRADO 3.0L 4cyl TD (KZJ90 KZJ95)
  • [04/96 - 12/02] TOYOTA LANDCRUISER PRADO 3.0L 4cyl TD (KZJ90_ KZJ95_)
  • [09/02 - 07/09] TOYOTA LANDCRUISER PRADO 3.0L 4cyl D-4D (KZJ12)
  • [09/02 - 12/10] TOYOTA LANDCRUISER PRADO 3.0L 4cyl D-4D (KDJ120 KDJ125 KDJ121)
  • [08/09 - on] TOYOTA LANDCRUISER PRADO 3.0L 4cyl D-4D (KDJ150_ KDJ150 KDJ155)
  •  
  • [12/12 - on] TOYOTA RAV4 2.2L 4cyl D 4WD (ALA49)
  •  
  • [07/06 - 09/06] FORD TRANSIT VM 2.4L 4cyl TD
  • [11/06 - 12/14] FORD TRANSIT VM 2.4L 4cyl TD AWD
  • [01/10 - 12/14] FORD TRANSIT VM 2.2L 4cyl TDCi
How do I test a coolant temperature sensor?

The most common test is to measure the sensor resistance with a multimeter at a known coolant temperature and compare against the manufacturer resistance curve. A cold engine (20 degrees C) typically reads 2,000 to 3,000 ohms and drops to around 200 to 300 ohms at operating temperature (90 degrees C). An OBD2 scanner showing a fixed temperature reading that does not change as the engine warms up is also a strong indicator of sensor failure.

Can a faulty coolant temperature sensor cause my engine to overheat?

Indirectly yes. If the sensor reports a lower temperature than actual, the ECU may not activate the cooling fan at the correct time, allowing the engine to overheat. It can also suppress the dashboard warning light, meaning you may not be alerted until the engine is already at a dangerously high temperature. Replace a suspected faulty sensor promptly.

Do I need to drain the coolant to replace the sensor?

Not always - many coolant temperature sensors can be replaced quickly with minimal coolant loss if you work fast and have a replacement ready to thread in immediately. However on some vehicles the sensor location requires partial coolant drainage. Check the sensor position on your specific engine before starting. Always use fresh coolant when topping up after replacement.

What are the symptoms of a faulty coolant temperature sensor?

Symptoms include poor fuel economy, black smoke, engine overheating warning, incorrect temperature gauge reading, hard starting when cold, and rough idle. Fault codes P0115 to P0119 are commonly associated with coolant temperature sensor faults.

Is it safe to drive with a bad coolant temperature sensor?

A faulty coolant temperature sensor can cause the ECU to run rich fuel mixtures and prevent the cooling fan from operating correctly, risking engine overheating. Replace it promptly - it is a low-cost part that can prevent expensive engine damage.

How do I know if my coolant temperature sensor or my thermostat is faulty?

A faulty thermostat typically causes the engine to overheat or never reach operating temperature. A faulty coolant temp sensor causes incorrect gauge readings and running issues but the coolant itself may be at the correct temperature. An OBD2 scanner showing live coolant temp data helps distinguish between the two.

Are there two coolant temperature sensors on my vehicle?

Many vehicles have two sensors - one for the ECU (engine management) and one for the dashboard temperature gauge. They look similar but are not interchangeable. Check your vehicle's service manual or contact us with your vehicle details to confirm which sensor you need.

Identification
SKU8945460010
BrandAftermarket OEM Replacement
Part Numbers
Part NumberFTS105
Reference OEM Number89454-60010
Other OEM Numbers89454-20010, 89454-60010, 89454-60020, 98023581, 1441571
Trade Part NumbersV32-72-0024, 6PT 013 113-141
Product Specifics
Product TypeSENSOR
Sensor TypeFuel / Coolant Temperature Sensor
Thread SizeM12x1.5
Spanner Size19mm
Number of pins2-Pin
Connector Shapeoval
Housing ColourGrey
Compatible MakesToyota, Ford, Isuzu, Holden, Opel, Suzuki
Fitment TypeDirect Replacement
Other Details
NoteOval 2-pin connector - confirm shape before ordering.
Unit Of Measureea

Be The First To Review This Product!

Help other SENSORGAL LTD. users shop smarter by writing reviews for products you have purchased.

Write a product review

More From This Category