Coolant Temperature Sensor for KIA Sportage Carnival Mentor Credos Carens

Coolant Temperature Sensor for KIA Sportage Carnival Mentor Spectra Credos

Part #: CCS20 OEM #: 0K011-18840 SKU: CCS20-KIA

Direct Fit Replaces 0K011-18840

$49.00
RRP $80.00
SAVE $31.00 (39%)
In Stock

BRAND NEW *OEM Quality* Coolant Temperature Sensor to suit KIA Sportage Carnival Mentor Shuma Spectra Credos and Carens.

When your coolant temperature sensor fails the ECU loses its main temperature input - causing hard cold starts, rich fuel mixture, erratic temperature gauge and fault codes P0115 / P0116 or P0117. This is a direct-fit replacement using the original 2-pin green rectangular connector with M12x1.5 thread and includes a replacement gasket/seal. Same-day dispatch from Cranbourne VIC.

TO SUIT

KIA Sportage KM 2.0L FE (1996-2004) - KIA Carnival FL / GQ 1.8L T8 / 2.5L KV6 (1997-2006) - KIA Mentor / Shuma 1.5L B5 / 1.5L BFD / 1.8L T8/TE (1996-2001) - KIA Spectra SD 1.8L T8 / 2.0L FE (1998-2002) - KIA Credos CR 2.0L FE (1998-2001) - KIA Carens FJ 2.0L FE (1996-2004).

FITMENT CHECK

This sensor suits vehicles fitted with the standard 2-pin green rectangular M12x1.5 connector. Some Carnival and Mentor variants have construction year restrictions - check the full compatibility list before ordering.

OEM PART NUMBERS

  • 0K011-18840 (KIA primary)
  • 0K054-1884X (KIA)
  • 0K95B-18840 (KIA)
  • K8574-18840 (KIA)

OTHER PART NUMBERS

  • VEMO: V38-72-0002
  • HELLA: 6PT 009 107-441
  • WALKER PRODUCTS: 210-1007
  • BERU: ST226

PACKAGE INCLUDES

1 x Coolant Temperature Sensor - 2-pin green rectangular connector / M12x1.5 thread / 19mm spanner / gasket/seal included.

ABOUT THIS SENSOR

The Coolant Temperature Sensor (CTS) monitors engine coolant temperature and sends a voltage signal back to the ECU. The ECU uses this reading to regulate fuel injection duration, ignition timing, cold start enrichment, idle speed, and cooling fan activation.

When the sensor fails the ECU operates without accurate temperature data causing rough running, poor fuel economy, and hard cold starts.

COMMON SYMPTOMS OF FAILURE

  • Check engine light on - fault codes P0115 / P0116 / P0117
  • Temperature gauge stuck, reading high or fluctuating
  • Engine running rich - excessive fuel consumption
  • Hard starting when cold - extended cranking required
  • Rough idle or stalling when engine is cold
  • Cooling fan not activating or activating late
  • KIA CARENS FJ 2.0L FE [01/96 - 12/04]
  • KIA CARNIVAL FL 1.8L T8 [01/97 - 12/00]
  • KIA CARNIVAL GQ 2.5L KV6 [01/01 - 12/06]
  • KIA CREDOS CR 2.0L FE [01/98 - 12/01]
  • KIA MENTOR 1.5L B5 [01/96 - 12/98]
  • KIA MENTOR 1.5L BFD [01/97 - 12/01]
  • KIA SHUMA 1.5L BFD [01/97 - 12/01]
  • KIA SHUMA 1.8L T8 / TE [01/97 - 12/01]
  • KIA SPECTRA SD 1.8L T8 [01/98 - 12/02]
  • KIA SPECTRA SD 2.0L FE [01/98 - 12/02]
  • KIA SPORTAGE KM 2.0L FE [01/96 - 12/04]
How do I test a coolant temperature sensor?

The most common test is to measure the sensor resistance with a multimeter at a known coolant temperature and compare against the manufacturer resistance curve. A cold engine (20 degrees C) typically reads 2,000 to 3,000 ohms and drops to around 200 to 300 ohms at operating temperature (90 degrees C). An OBD2 scanner showing a fixed temperature reading that does not change as the engine warms up is also a strong indicator of sensor failure.

Can a faulty coolant temperature sensor cause my engine to overheat?

Indirectly yes. If the sensor reports a lower temperature than actual, the ECU may not activate the cooling fan at the correct time, allowing the engine to overheat. It can also suppress the dashboard warning light, meaning you may not be alerted until the engine is already at a dangerously high temperature. Replace a suspected faulty sensor promptly.

Do I need to drain the coolant to replace the sensor?

Not always - many coolant temperature sensors can be replaced quickly with minimal coolant loss if you work fast and have a replacement ready to thread in immediately. However on some vehicles the sensor location requires partial coolant drainage. Check the sensor position on your specific engine before starting. Always use fresh coolant when topping up after replacement.

What are the symptoms of a faulty coolant temperature sensor?

Symptoms include poor fuel economy, black smoke, engine overheating warning, incorrect temperature gauge reading, hard starting when cold, and rough idle. Fault codes P0115 to P0119 are commonly associated with coolant temperature sensor faults.

Is it safe to drive with a bad coolant temperature sensor?

A faulty coolant temperature sensor can cause the ECU to run rich fuel mixtures and prevent the cooling fan from operating correctly, risking engine overheating. Replace it promptly - it is a low-cost part that can prevent expensive engine damage.

How do I know if my coolant temperature sensor or my thermostat is faulty?

A faulty thermostat typically causes the engine to overheat or never reach operating temperature. A faulty coolant temp sensor causes incorrect gauge readings and running issues but the coolant itself may be at the correct temperature. An OBD2 scanner showing live coolant temp data helps distinguish between the two.

Are there two coolant temperature sensors on my vehicle?

Many vehicles have two sensors - one for the ECU (engine management) and one for the dashboard temperature gauge. They look similar but are not interchangeable. Check your vehicle's service manual or contact us with your vehicle details to confirm which sensor you need.

Identification
SKUCCS20-KIA
BrandSensorGal
Part Numbers
Part NumberCCS20
Reference OEM Number0K011-18840
Other OEM Numbers0K011-18840 0K054-1884X 0K95B-18840 K8574-18840
Trade Part NumbersVEMO: V38-72-0002, HELLA: 6PT 009 107-441, BERU: ST226
Product Specifics
Other Details
Note2-pin green rectangular M12x1.5 19mm - gasket/seal included

Be The First To Review This Product!

Help other SENSORGAL LTD. users shop smarter by writing reviews for products you have purchased.

Write a product review

More From This Category