Coolant Temperature Sensor for Hyundai Sonata EF Kia Optima V6
Direct Fit Replaces 39220-35710
BRAND NEW *OEM Quality* coolant temperature sensor to suit Hyundai Sonata EF, Grandeur XG and Kia Optima GD petrol engines.
A failed coolant sensor sends the wrong temperature to the ECU, causing poor fuel economy, a rough idle or a check engine light. This direct-fit replacement matches the factory 2-pin plug, with same-day dispatch before 12pm from Victoria.
TO SUIT
- Hyundai Sonata EF 2.0L G4JP, 2.4L and 2.5L/2.7L V6 G6BV G6BA (1998-2004)
- Hyundai Grandeur XG 2.5L V6 (1998-2002)
- Kia Optima GD 2.5L V6 G6BV (2001-2003)
OEM PART NUMBERS
- 39220-35710
- 39220-35700
OTHER PART NUMBERS
- V37-72-0004
- 6PT 009 107-121
- ECT-MS-000
- 211-1030
- TS10327
PACKAGE INCLUDES
1 x OEM Quality engine coolant temperature sensor with 2-pin rounded rectangular connector and 3/8 GAS thread.
ABOUT THIS SENSOR
The coolant temperature sensor reports engine temperature to the ECU, which uses it to manage fuel mixture, idle speed and cooling fan operation on the Sonata, Grandeur and Optima G-series engines.
On the 2.5L and 2.7L V6 a sensor stuck reading cold commonly shows up as the radiator fan running constantly, black smoke at start-up and noticeably worse fuel economy.
COMMON SYMPTOMS OF FAILURE
- Check engine light with fault code P0116, P0117 or P0118
- Poor fuel economy or rough idle
- Radiator fan running constantly or not at all
- Incorrect temperature gauge reading
- Engine running rich or lean
- Hesitation on acceleration
- [12/98 - 11/02] HYUNDAI GRANDEUR XG 250 (2.5L V6 120kW)
- [06/98 - 04/00] HYUNDAI SONATA EF IV 16V (2.0L 4cyl G4JP 100kW)
- [03/98 - 05/01] HYUNDAI SONATA EF IV 16V (2.4L 4cyl 105kW)
- [08/98 - 09/01] HYUNDAI SONATA EF IV i V6 (2.5L V6 G6BV 127kW)
- [08/98 - 12/00] HYUNDAI SONATA EF IV V6 24V (2.5L V6 G6BV 118kW)
- [10/01 - 11/04] HYUNDAI SONATA EF IV V6 (2.7L V6 G6BA 127kW)
- [05/01 - 02/03] KIA OPTIMA GD / MS I V6 (2.5L V6 G6BV 124kW)
How do I test a coolant temperature sensor?
The most common test is to measure the sensor resistance with a multimeter at a known coolant temperature and compare against the manufacturer resistance curve. A cold engine (20 degrees C) typically reads 2,000 to 3,000 ohms and drops to around 200 to 300 ohms at operating temperature (90 degrees C). An OBD2 scanner showing a fixed temperature reading that does not change as the engine warms up is also a strong indicator of sensor failure.
Can a faulty coolant temperature sensor cause my engine to overheat?
Indirectly yes. If the sensor reports a lower temperature than actual, the ECU may not activate the cooling fan at the correct time, allowing the engine to overheat. It can also suppress the dashboard warning light, meaning you may not be alerted until the engine is already at a dangerously high temperature. Replace a suspected faulty sensor promptly.
Do I need to drain the coolant to replace the sensor?
Not always - many coolant temperature sensors can be replaced quickly with minimal coolant loss if you work fast and have a replacement ready to thread in immediately. However on some vehicles the sensor location requires partial coolant drainage. Check the sensor position on your specific engine before starting. Always use fresh coolant when topping up after replacement.
What are the symptoms of a faulty coolant temperature sensor?
Symptoms include poor fuel economy, black smoke, engine overheating warning, incorrect temperature gauge reading, hard starting when cold, and rough idle. Fault codes P0115 to P0119 are commonly associated with coolant temperature sensor faults.
Is it safe to drive with a bad coolant temperature sensor?
A faulty coolant temperature sensor can cause the ECU to run rich fuel mixtures and prevent the cooling fan from operating correctly, risking engine overheating. Replace it promptly - it is a low-cost part that can prevent expensive engine damage.
How do I know if my coolant temperature sensor or my thermostat is faulty?
A faulty thermostat typically causes the engine to overheat or never reach operating temperature. A faulty coolant temp sensor causes incorrect gauge readings and running issues but the coolant itself may be at the correct temperature. An OBD2 scanner showing live coolant temp data helps distinguish between the two.
Are there two coolant temperature sensors on my vehicle?
Many vehicles have two sensors - one for the ECU (engine management) and one for the dashboard temperature gauge. They look similar but are not interchangeable. Check your vehicle's service manual or contact us with your vehicle details to confirm which sensor you need.
| Identification | |
|---|---|
| Brand | Aftermarket OEM Replacement |
| Part Numbers | |
| Part Number | SCCS39 |
| Reference OEM Number | 3922035710 |
| Other OEM Numbers | 39220-35710, 39220-35700 |
| Related Part Numbers | CCS39, CS838, TCS055, TS337 |
| Interchange Part Numbers | V37-72-0004, 6PT 009 107-121, ECT-MS-000 |
| Product Specifics | |
| Product Type | SENSOR |
| Sensor Type | ENGINE COOLANT TEMPERATURE SENSOR |
| Manufacturer Warranty | 1 Year |
| Thread Size | 3/8 GAS |
| Spanner Size | 19 mm |
| Number of pins | 2-Pin |
| Connector Shape | oval |
| Housing Colour | Black |
| Compatible Makes | Hyundai, Kia |
| Fitment Type | Direct Replacement |
| Other Details | |
| Note | Always verify fitment using your vehicle's OEM part number. |
| Unit Of Measure | ea |
Be The First To Review This Product!
Help other SENSORGAL LTD. users shop smarter by writing reviews for products you have purchased.