







Coolant Temp Sensor for Toyota Echo Starlet Paseo bB & Daihatsu Sirion Terios
Direct Fit Replaces 89422-16010
BRAND NEW *OEM Quality* engine coolant temperature sensor to suit Toyota Echo, Starlet, Paseo, Porte, Caldina and bB, and Daihatsu Sirion, Terios and YRV.
On these small petrol engines a failing sensor usually shows as an idle that hunts when cold and a thermo fan that runs from the moment you start. A new sensor settles both. Same-day dispatch before 12pm from Victoria.
TO SUIT
- Toyota Echo NCP10, NCP12 and NCP13 with 1NZ-FE and 2NZ-FE
- Toyota Starlet EP91, Paseo EL54 and Spacia SR40
- Toyota Porte NNP10 and NNP11, Caldina ST215W and ST246W
- Toyota bB QNC20 with K3-VE
- Daihatsu Sirion M101 and M301, Terios J102 and YRV M201 with K3-VE
FITMENT CHECK
Toyota and Daihatsu share the K3-VE engine and this sensor across both brands. Confirm the 3-pin triangular plug and M12 x 1.5 thread against your original, as the smaller Toyota petrol range used more than one coolant sensor.
OEM PART NUMBERS
- 89422-16010
- 89422-22030
- 8942216010
- 8942222030
- 89422BZ010
OTHER PART NUMBERS
- VEMO: V70-72-0120-1
- WALKER: 211-1117
- MTE-Thomson: 4255
- Goss: CS844
- TCS125
- CTS-030
- TX85
PACKAGE INCLUDES
1 x engine coolant temperature sensor with 3-pin triangular plug and seal ring.
ABOUT THIS SENSOR
The K3-VE and NZ series engines use coolant temperature to control cold enrichment, idle-up and the electric thermo fan. These are light cars with small cooling systems, so an incorrect reading shows up in driveability much faster than it would on a larger engine.
Age is the usual cause here rather than heat. Most of these cars are now well past twenty years old and the sensor has simply drifted with time in service.
COMMON SYMPTOMS OF FAILURE
- Fault codes P0115, P0116, P0117 or P0118 stored
- Idle hunting or surging while the engine is cold
- Thermo fan running constantly from a cold start
- Poor fuel economy and a strong fuel smell at the exhaust
- Temperature gauge inaccurate or slow to rise
- Stalling shortly after a cold start
- [2000 - 2005] DAIHATSU SIRION M101 (1.3L 4cyl K3-VE2 75kW)
- [2005 - 2008] DAIHATSU SIRION M301 (1.3L 4cyl K3-VE 64kW)
- [2000 - 2006] DAIHATSU TERIOS J102 (1.3L 4cyl K3-VE 63kW)
- [2001 - 2005] DAIHATSU YRV M201 (1.3L 4cyl K3-VE 64kW)
- [1997 - 2001] TOYOTA CALDINA ST215W (2.0L 4cyl 3S-GTE 140kW)
- [2002 - 2007] TOYOTA CALDINA ST246W (2.0L 4cyl 3S-GTE 191kW)
- [2002] TOYOTA CAMRY ACV36 (2.4L 4cyl 2AZ-FE 112kW)
- [1999 - 2005] TOYOTA ECHO NCP10 (1.3L 4cyl 2NZ-FE 63kW)
- [1999 - 2005] TOYOTA ECHO NCP12 (1.5L 4cyl 1NZ-FE 78kW)
- [2001 - 2005] TOYOTA ECHO NCP13 (1.5L 4cyl 1NZ-FE 78kW)
- [1995 - 1999] TOYOTA PASEO EL54 (1.5L 4cyl 5E-FE 69kW)
- [2004 - 2012] TOYOTA PORTE NNP10 (1.3L 4cyl 2NZ-FE 64kW)
- [2004 - 2012] TOYOTA PORTE NNP11 (1.5L 4cyl 1NZ-FE 81kW)
- [1998 - 2002] TOYOTA SPACIA SR40 (2.0L 4cyl 3S-FE 94kW)
- [1996 - 1999] TOYOTA STARLET EP91 (1.3L 4cyl 4E-FE 55kW)
- [2005 - 2016] TOYOTA BB QNC20 (1.3L 4cyl K3-VE 68kW)
How do I test a coolant temperature sensor?
The most common test is to measure the sensor resistance with a multimeter at a known coolant temperature and compare against the manufacturer resistance curve. A cold engine (20 degrees C) typically reads 2,000 to 3,000 ohms and drops to around 200 to 300 ohms at operating temperature (90 degrees C). An OBD2 scanner showing a fixed temperature reading that does not change as the engine warms up is also a strong indicator of sensor failure.
Can a faulty coolant temperature sensor cause my engine to overheat?
Indirectly yes. If the sensor reports a lower temperature than actual, the ECU may not activate the cooling fan at the correct time, allowing the engine to overheat. It can also suppress the dashboard warning light, meaning you may not be alerted until the engine is already at a dangerously high temperature. Replace a suspected faulty sensor promptly.
Do I need to drain the coolant to replace the sensor?
Not always - many coolant temperature sensors can be replaced quickly with minimal coolant loss if you work fast and have a replacement ready to thread in immediately. However on some vehicles the sensor location requires partial coolant drainage. Check the sensor position on your specific engine before starting. Always use fresh coolant when topping up after replacement.
What are the symptoms of a faulty coolant temperature sensor?
Symptoms include poor fuel economy, black smoke, engine overheating warning, incorrect temperature gauge reading, hard starting when cold, and rough idle. Fault codes P0115 to P0119 are commonly associated with coolant temperature sensor faults.
Is it safe to drive with a bad coolant temperature sensor?
A faulty coolant temperature sensor can cause the ECU to run rich fuel mixtures and prevent the cooling fan from operating correctly, risking engine overheating. Replace it promptly - it is a low-cost part that can prevent expensive engine damage.
How do I know if my coolant temperature sensor or my thermostat is faulty?
A faulty thermostat typically causes the engine to overheat or never reach operating temperature. A faulty coolant temp sensor causes incorrect gauge readings and running issues but the coolant itself may be at the correct temperature. An OBD2 scanner showing live coolant temp data helps distinguish between the two.
Are there two coolant temperature sensors on my vehicle?
Many vehicles have two sensors - one for the ECU (engine management) and one for the dashboard temperature gauge. They look similar but are not interchangeable. Check your vehicle's service manual or contact us with your vehicle details to confirm which sensor you need.
| Identification | |
|---|---|
| SKU | CCS99-1 |
| Brand | Aftermarket OEM Replacement |
| Part Numbers | |
| Part Number | CCS99 |
| Reference OEM Number | 8942216010 |
| Other OEM Numbers | 89422-16010, 89422-22030, 8942216010, 8942222030, 89422BZ010 |
| Related Part Numbers | CTS-030, CCS93, CS844, TCS125, TX85 |
| Trade Part Numbers | VEMO: V70-72-0120-1, WALKER: 211-1117, MTE-Thomson: 4255 |
| Product Specifics | |
| Product Type | SENSOR |
| Sensor Type | Coolant Temperature Sensor |
| Manufacturer Warranty | 1 Year |
| Thread Size | M12x1.5 |
| Spanner Size | 19mm |
| Number of pins | 3-Pin |
| Connector Shape | triangular |
| Supplementary Article Info | with seal ring |
| Housing Colour | Grey |
| Mounting Type | Threaded |
| Compatible Makes | Toyota / Daihatsu |
| Fitment Type | Direct Replacement |
| Other Details | |
| Note | 3-pin triangular plug, M12x1.5 thread, 19mm spanner |
| Unit Of Measure | ea |
Be The First To Review This Product!
Help other SENSORGAL LTD. users shop smarter by writing reviews for products you have purchased.